美女被免费网站视频九色-美女被啪到哭网站在线观看-美女被拍拍拍拍拍拍拍拍-美女被色-4438x亚洲最大-4444狠狠

你現在的位置:首頁>企業動態

雙組份打膠機的結構原理

瀏覽:0
雙組份打膠機是生產中空、幕墻玻璃的專用設備,可一次完成二道密封中A、B組份混合與涂膠。適用配比精度高的膠種,滿足玻璃深加工企業率、高合格率流水線作業的生產需求,是大規模生產高檔中空玻璃及玻璃幕墻產品的一種理想的配套設備。
The two-component gluing machine is a special equipment for producing hollow and curtain wall glass, which can complete the mixing and gluing of components a and B in two seals at one time. It is an ideal equipment for mass production of high-quality insulating glass and glass curtain wall products.
雙組份打膠機由A、B膠泵、氣動系統、升降機構、機架等組成。現分別介紹如下:
The two-component glue applicator consists of a and B glue pumps, pneumatic system, lifting mechanism, frame, etc. It is introduced as follows:
1.膠泵:
1. Rubber pump:
(1)A、B組份各設一個膠泵,在各自的氣馬達驅動下,分別作往復運動,將膠吸入并壓出。A、B膠泵分別與壓膠盤固定在一起,再與機架連接組成各自的系統。
(1) A rubber pump is set for component A and component B respectively. Driven by their respective air motors, they move back and forth respectively to draw in and press out the rubber. A. B glue pump is respectively fixed with the pressure glue disk, and then connected with the frame to form their own system.
(2)A、B組份的配比是通過比例杠桿進行調節:向里調節,B出膠量減少,向外調節,B出膠量增加。通過調節比例杠桿來控制B膠的出膠量,從而控制A、B膠的配比。
(2) The proportion of components a and B is adjusted by the proportion lever: adjust inwards, the glue output of B decreases, adjust outwards, and the glue output of B increases. Adjust the proportion lever to control the glue output of B glue, so as to control the proportion of a and B glue.
(3)出膠量:由氣源處理器控制,逆時針調節,出膠量增加,順時針調節出膠量減小。(這里指總出膠量)
(3) Glue output: controlled by the air source processor, it can be adjusted anticlockwise to increase the glue output and clockwise to reduce the glue output. (this refers to the total glue output)
本膠泵通過比例杠桿調節A、B膠量配比,具有操作靈活,性能穩定,調節范圍大等特點。
The rubber pump can adjust the ratio of a and B rubber through the proportion lever, which has the characteristics of flexible operation, stable performance, large adjustment range, etc.
2 . 升降機構:
2. Lifting mechanism:
A、B組份膠泵分別設一套氣動升降機構,該升降機構分別由兩個氣缸并聯組成,并通過橫梁固定連接各自的泵體。其目的之一是將兩缸的作用力通過壓盤作用在膠面上,壓力大小由調壓閥調節,一般調整在0.3MPa左右;其二,當需要更換膠桶時,氣缸可將壓盤提起。離開膠桶,以便更換新的膠桶。
A. Component B rubber pump is respectively provided with a set of pneumatic lifting mechanism, which is composed of two cylinders in parallel, and is fixedly connected with each pump body through a cross beam. One of its purposes is to apply the force of two cylinders on the rubber surface through the pressure plate, and the pressure is adjusted by the pressure regulating valve, generally around 0.3MPa; second, when the rubber barrel needs to be replaced, the cylinder can lift the pressure plate. Leave the drum in order to replace it with a new one.

上一篇:雙組份打膠機使用完怎么清洗?需要清洗嗎?
下一篇:雙組份打膠機掃描尺是什么?

  • 微信
主站蜘蛛池模板: 午夜在线播放免费人成无 | 亚洲欧美日韩久久精品第一区 | 日韩精品福利视频一区二区三区 | 国产精品香蕉一区二区三区 | www.午夜 | 久久成人激情视频 | 最近中文字幕完整视频高清10 | www精品一区二区三区四区 | 日本午夜在线视频 | 日b视频免费看 | 天天靠天天擦天天摸 | 成人性生交大片免费看午夜a | 日韩精品高清自在线 | 麻豆入口 | 妞干网手机免费视频 | 欧美成人激情视频 | 国产亚洲人成在线影院 | 国产视频一区二区 | 欧美一区二区三区不卡免费 | 自拍 亚洲 欧美 另类 动漫 | 国产精品视频第一区二区 | 亚洲欧美中文字幕 | 虫族bl文全肉高h | 清风阁爱干 | 日日干夜夜爱 | 欧美日韩国产高清一区二区三区 | 中文字幕在线视频免费观看 | 亚洲精品午夜 | 日日草视频 | 午夜性刺激免费视频观看不卡专区 | 日皮视频在线免费观看 | 五月综合久久 | 亚洲成熟xxxxx | 香蕉99国内自产自拍视频 | 亚欧洲乱码专区视频 | 国产一区在线观看视频 | 日本波多野结衣在线 | 亚洲无线一二三四区手机 | 日韩综合在线观看 | 国产片a国产片免费看视频 国产片黄色 | 26uuu另类亚洲欧美日本一 |