雙組份打膠機的注意事項
1.由于濟南雙組份打膠機密封膠的固化需要一定時間，因此，已涂了雙組份密封膠的玻璃應水平輕輕搬動。
1., due to the need for a certain amount of time to solidify the glue of the two components in Ji'nan, the glass of two components sealant should be gently moved.
2.A組、B組份膠應保持清潔，嚴防異物進入膠中。
Group 2.A and B components should be kept clean, and foreign matters should be strictly prevented from entering the glue.
3.在連續工作過程中，膠槍每次停止工作時間一般不得超過20分鐘，否則，應用A組份膠沖出全部混合膠，直單一的A組份膠從槍口排出為止。
3. in the continuous working process, the glue gun will not stop working more than 20 minutes each time. Otherwise, all the mixed glue is washed out with A component glue until the single A component is discharged from the muzzle.
4.高壓膠管不得強行擠壓、彎曲，防止影響系統正常工作。
4., high pressure hose should not be forced to bend or bend to prevent the system from functioning normally.
5.混膠器應經常保持暢通，以保證良好的出膠效果。如遇堵塞情況，可用丙酮浸泡后清洗。建議每5組清洗一次。
5., rubber mixer should be kept regular and smooth, so as to ensure good glue production. In case of clogging, acetone can be soaked and cleaned. It is suggested that every 5 groups be cleaned once.
6.濟南雙組份打膠機當膠槍長時間不用時（超過一周），應拆下槍體使用溶劑將膠槍和混膠器內的殘留膠體清洗干凈。
6. Ji'nan double component glue machine should be removed when the glue gun is not used for a long time (more than one week), and the gun body should be dismantled to clean the glue gun and the residual colloid in the glue mixer.
7.不同雙組份膠生產廠家所生產的膠內含雜質數量不同，根據實際情況清晰B組分的過濾網及單向止回閥，建議每兩組清洗一次。
7. the number of impurities in the rubber produced by the different double component rubber manufacturers is different. According to the actual situation, the filter net and the one-way check valve of the B component are clear. It is suggested that every two groups be cleaned once.
8.任何因膠體固化所造成的膠槍、管路或整機的故障，一律不在保修范圍之內。
8., any failure of glue gun, pipeline or whole machine caused by gel solidification is not guaranteed.
本文由
濟南雙組份打膠機友情奉獻,更多有關的知識請點擊:
http://www.vrqf.com.cn我們將用的技術，真誠的態度,為您提供為的服務。我們將會陸續向大家奉獻，敬請期待。
This article by Ji'nan double component glue machine friendship dedication, more related knowledge please click:
http://www.vrqf.com.cn we will use the most advanced technology, the most sincere attitude, to provide you with the most comprehensive service. We will continue to dedicate to you. Please look forward to it.
上一篇：中空玻璃手工刮膠該怎么操作？
下一篇：雙組份打膠機的注意事項
